Complete WPC fence systems Panel incl. post from €328 incl. VAT Personal advice: +31 591 230035
Stiffness
No steel

No steel or aluminium reinforcement needed in the boards. The hollow chambers with internal ribs, the wall thickness and the dense material make the board stiff enough on its own.

Why is that better?

Many WPC fences need metal profiles inside the boards to stop them sagging. Metal and WPC expand differently in heat and cold, which causes stress, and steel can rust if moisture gets into the board. Without reinforcement the board is lighter and you avoid those risks. This applies to standard installation in normal wind zones; for very exposed or coastal locations we recommend additional measures.

Dimensional stability
Straight

Designed for a clean, straight finish. The boards are produced to tight tolerances, so any deformation is not visible to the eye.

And the colour?

The protective outer layer is designed for long-lasting colour retention and tested for artificial weathering. Outdoors every material changes gradually with sun and weather, but without painting or staining the colour stays calm.

Warranty
10years

Commercial product warranty subject to the warranty terms, with checks during several production stages and selected batch tests.

*Conditions

Normal discolouration, ageing, material movement and incorrect installation are not covered by the warranty. Read the full warranty terms.

Doorsnede van een Classic co-extrusion WPC-plank van 20 mm dik, met zes holle kamers, tand-en-groef en een beschermende buitenlaag 20 mm 1 2 3 4 4
  1. 1Surface texture
  2. 2Protective outer layer
  3. 3WPC core with 6 hollow chambers
  4. 4Tongue-and-groove joint
Co-extrusion

A protective layer around the WPC core.

With co-extrusion, a protective outer layer is applied around the WPC profile during production. This layer helps protect the core against daily outdoor use and the weather.

  • No annual painting
  • Regular cleaning is enough
  • Wood texture in the top layer
  • Tongue and groove for a closed panel
How it works

Measure your garden, we calculate the rest.

Start configuring
  1. Measure your garden

    Measure the total length of each straight side and count the corners.

  2. Choose design and colour

    Classic or Linear, Charcoal or Golden Teak, and 11, 12 or 13 boards high.

  3. Receive your proposal

    A complete proposal with parts list: boards, posts, rails, brackets and self-tapping screws.